Tascam 44 OB output problem

Woody

New Member
Joined
Sep 15, 2021
Messages
6
Karma
0
Gear owned
44 OB
Hi All!
I recently bought a 44OB. The rca outputs work fine but I can’t hear any signal through the xlr outputs. Am I missing something obvious? Is there an internal jumper or switch to choose between rca/xlr? Any suggestions?
Thanks in advance.
 
There are often times two pole muting relays that go open coil and so they are changed in many decks. I use a Coto relay of the same configuration and 24Vdc. The coild are between 1100-1500 ohms when measured on relays from pin 2 to 6. I can provide model number of relays if you need it.
 
  • Like
Reactions: Redandrew
Someone may have plugged a cable with one of the phases shorted to ground, a common- wrong- way to unbalance a signal. The 44 uses a separate transistor balancing amp. So transistors got fried, you lost the higher voltage used for the balanced output amp. or fried the 10 ohm limiting resistors for the power feed to the output balance.
 
Hi All!

I would be very grateful if you could give me information on the model number of the relays to replace the original OMRON LAB2L 12V in my 58 tape recorder. All 4 relays seem to be open, which sounds a little strange but they are.

What is the exact COTO model number?

Thanks,
Regards
Andrea
 

New threads

Members online

No members online now.