Out of sram range and blue stripes on screen

[Giuseppe Barbera]

Hello everybody, as on the title i have two problems in my dm4800. since i have connected via tdif a motu 2408 standalone, to convert DA sgnals, all of a sudden i experiment this messages at every boot.
1- Out of SRAM range! . Initialize SRAM data? CH1 (82) eq sw.
i should initialize every time and recall from card the project, instead if i press a cursor key a new message appears, fatal error....etc, etc...

2- the screen start making the old story of blue orizontals stripes, a friends of mine said that it can happen because the TDIF cable connected.

did someone experiment the same issue? waiting for some help.
thanks
Peppe

 

[Hemming]

hello, did you solve the problem. I have the same issue.
Thomas

 

[Juzz]

This may be a long shot but I had the "Out of SRAM range!" error and it turns out it was the in board 3v battery needing replacing. It's not that difficult to do. Not sure about the other error you're getting. Good luck.

 

[traceoflife]

This is 100 percent correct. Battery is dying.
See tutorial on replacement.