Dom-4800 as clock slave

[Travis Kessler]

I have a DM-4800 in my studio. I just use it as a control surface and stereo bus from the daw is routed back to it. It is not used as an audio interface. I'm using an Antelope Orion32 as interface and work clock master. But I can't figure out how to get the clock settings on the DM-4800 to be a slave. I just want to be able to change the clock settings on the Orion32 (say from 96k to 44.1k) and have the DM-4800 do the same automatically. Is this possible? Thanks for any help

 

[ampsarus]

Connect your clock to the Sync In terminal with a 75 ohm cable. Press ALT and PROJECT. Press the CLOCK tab. Select WORD with the dial and press enter. Make sure 44.1/48 - 88.2/96 ranges are set correctly depending on the Fs you are using. On the left side of the console the EXT CLOCK light and a another light corresponding to the clocks Fs should be lit. Hope that helps!