- Joined
- Mar 21, 2021
- Messages
- 3
- Karma
- 1
- Gear owned
- Tascam Model 12
For channels 7/8 and 9/10, one of the sides is always a little louder.
If I'm going into 7/8, 8 is louder.
If it's 9/10, 10 is louder.
I've tried with different sources and swapped which side from the source is going into which channel, but channels 8 and 10 are consistently louder than 7 and 9. The pans for both channels are set to center, and the difference shows up on the input meters, so I believe whatever is happening is happening before and of the other things I could do to it on the board. It also shows up if I use the model 12 as an interface to record direcly into my DAW.
Has anyone else run into this? Is there an offset I can change somewhere? Thanks in advance!
If I'm going into 7/8, 8 is louder.
If it's 9/10, 10 is louder.
I've tried with different sources and swapped which side from the source is going into which channel, but channels 8 and 10 are consistently louder than 7 and 9. The pans for both channels are set to center, and the difference shows up on the input meters, so I believe whatever is happening is happening before and of the other things I could do to it on the board. It also shows up if I use the model 12 as an interface to record direcly into my DAW.
Has anyone else run into this? Is there an offset I can change somewhere? Thanks in advance!