Analog card routing

[patrickr2018]

Hey guys I just installed my analog card. How do I know that it's properly installed? How do I route signal through its output?

 

[Gerk]

DIGITAL->SLOT should at least tell you if it's there and working. And the ROUTING screen should give you a start on how to get stuff out of it.

 

[patrickr2018]

Thanks Gerk I actually found what I needed from another thread. Turns out you need to choose slot 1 in source select and slot 2 in terminal select then in output select assign slot 1 trk 1-8. Thanks again!!